Volvo XC90: Maintenance and service / Sending vehicle information to the workshop
(Certain markets only.
Vehicle-related information can be sent at any time from the vehicle, e.g.
if you schedule a visit to a workshop and would like to assist your workshop by
providing additional basic information. Sending vehicle information is not the same
as scheduling service.
- Open the Car Status app from App view in the center display.
- Tap Appointments.
- Tap Send vehicle data.
Vehicle information can be accessed by any retailer if they are provided with
your vehicle identification number (VIN2).
Vehicle information contents
The most recently saved vehicle-related information will be sent (the last time
the vehicle was turned on). This includes information regarding:
- service requirements
- time since last service was performed
- function status
- fluid levels
- mileage (odometer reading)
- Vehicle Identification Number (VIN2)
- software version
- diagnostic information.
1 There may be a charge for transmitting data over
the Internet, depending on your service plan.
2 Vehicle Identification Number.
(Certain markets only.)
This service offers a way to send a booking request for service and workshop
appointments directly from the vehicle.
When it is time for service, and in certain cases if the vehicle requires repairs,
a message will be displayed in the instrument panel and at the top of the center
display...
When hoisting the vehicle, it is important that the jack is positioned on
the designated points under the vehicle.
The triangles in the plastic covering indicate where the jack
attachment points/lifting points (red areas) are located...
Other information:
Cruise control (CC1) can be deactivated and switched off.
Press the button on the steering
wheel (2).
The symbol and markings turn gray – cruise control goes into standby
mode.
Press the (1) or
(3) buttons on the steering wheel
to select another function...
Private locking is activated using the function button in the center display
and a PIN code.
NOTE
For the valet lock function to be activated the car must be in at least
ignition mode I.
Two codes are used for private locking:
A security code, which is created the first time the function is used...